The NaviControlCenter cannot identify my navi2move. What is wrong?


Please install the NaviControlCenter once more and make sure that at the end of the installation also the device drivers are installed. If the drivers are properly installed you will find the following entry under system control à programs:

 Silicon Laboratoiries CP210x USB to UART Bridge

In addition you can check if the device is connected properly: Therefore you need to check up under system control à hardware manager.  You should see the navi2move driver (Silicon Laboratoiries CP210x USB to UART Bridge) at “computer link (COM & LPT).

If this is not the case, please contact us so that we can find a reason for the problem together.

Tags: navi control center, Navi2move
Last update:
2012-11-30 09:54
Author:
o-synce support team
Revision:
1.1
Average rating: 3 (4 Votes)

You cannot comment on this entry

Chuck Norris has counted to infinity. Twice.